MTD E760, E740 manual Contents Of Hardware Pack

SECTION 4: CONTENTS OF HARDWARE PACK

Lay out the hardware according to the illustration for identification purposes. Parts are illustrated approximately one-half size. Part numbers are shown in parentheses.

(Hardware pack may contain extra items which are not used on your unit.)

A ATTACHING THE HANDLE ASSEMBLY				B ATTACHING THE CHUTE ASSEMBLY
Hex Bolts					Hex Bolts
5/16-18 x 1-3/4" Long
					1/4-20 x 3/4" Long
(710-3180)
					(710-3015)
	Hex Bolts
	5/16-18 x 3/4" Long			Hex Lock Nuts
	(710-3008)			1/4-20 Thread
	Lock Washers		Handle Tabs	(712-3027)
	5/16" I.D.		(784-5599)
	(736-0119)
Carriage Bolts
5/16-18 x 1-1/2" Long					Chute Flange
(710-0262)					Keepers
Cupped Washers					(731-0851A)
5/16" I.D.
(736-0242)
Hex Nuts
5/16-18 Thread
(712-3010)
C ATTACHING THE CHUTE CRANK				D ATTACHING THE SHIFT ROD
Flat Washers				AND CLUTCH CABLES
					Hairpin Clips
3/8" I.D. x 5/8" O.D.				Ferrule
(736-0185)	Hex Bolt				(714-0104)
				(711-0677)
	5/16-18 x 1-1/2"
	Long			Flat Washers
	(710-0442)			5/16" I.D. x 5/8" O.D.
				(736-0264)
	Lock Washer
	5/16" I.D.
	(736-0119)
Hairpin Clip	Hex Nut
(714-0104)	5/16-18 Thread
	(712-3010)
F AUGER SHEAR BOLTS				G ATTACHING THE TRACK CONTROLS
The augers are secured to the spiral shaft with two shear bolts
and hex lock nuts. If you hit a foreign object or ice jam, the snow
thrower is designed so that the bolts will shear. Two replace-
ment shear bolts and nuts are provided for your convenience.
Store in a safe place until needed.
		Hex Lock Nuts
	Shear Bolts	5/16-18 Thread
	5/16-18 x	(712-0429)
	1-1/2" Long
	(710-0890A)			Track Control Triggers
				5