Drive Shaft

AUGER CLUTCH ADJUSTMENT

To adjust the auger clutch, refer to the Final Adjustments section page 10.

SHIFT ROD ADJUSTMENT

Sprocket

Shaft

Drive Cable

To adjust the shift rod, remove the hairpin clip and flat washer which secure the ferrule to the shift lever, beneath the handle panel. Refer to Figure 15. Refer to the Final Adjustments section.

 

Pivot

Friction

Rod

Wheel

 

 

Friction

 

Plate

 

Figure 20

CARBURETOR ADJUSTMENT

WARNING: If any adjustments are made to the engine while the engine is running (e.g. carburetor), keep clear of all moving parts. Be careful of heated surfaces and muffler.

Minor carburetor adjustment may be required to compensate for differences in fuel, temperature, altitude and load.

Refer to the separate engine manual packed with your unit for carburetor adjustment information.

SECTION 9: LUBRICATION

WARNING: Disconnect the spark plug wire and ground against the

engine before performing any lubrication or maintenance.

AUGER SHAFT

At least once a season, remove shear bolts on auger shaft. Oil or spray lubricant inside shaft. See Figure

21.Also lubricate the plastic bearings at least once a season.

Shear Bolts

Plastic Bearings

Figure 21

ENGINE

Refer to engine manual for all engine lubrication instructions.

AXLE BEARINGS

Oil or spray lubricant into axle bearings at the housing at least once a season.

SPROCKET SHAFT

Lubricate the sprocket shaft with good all-weather multi-purpose light grease at least once a season or after every 25 hours of operation.

IMPORTANT: Keep all grease and oil off of the rubber friction wheel and aluminum drive plate.

DRIVE AND SHIFTING MECHANISM

At least once a season or after every 25 hours of operation, remove rear cover. Lubricate any chains, sprockets, gears, bearings, shafts, and shifting mechanism at least once a season. Use engine oil or a spray lubricant. Avoid getting oil on rubber friction wheel and aluminum drive plate. Refer to Figure 20.

14

Page 14
Image 14
MTD E762F manual Lubrication