Loop
Fig. 9
9.Wind the line in tight even layers in the direction indicated on the inner reel. (Fig. 10)
Fig. 10
NOTE: Failure to wind the line in the direction indicated will cause the cutting attachment to operate incorrectly.
10. Insert the ends of the line into the two holding slots (Fig. 11).
Holding Slots
Fig. 11
11.Insert the ends of the line through the eyelets in the outer spool and place inner reel with spring inside the outer spool (Fig. 12). Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the reel.
NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.
12.Hold the inner reel in place and install the Bump Knob by turning counterclockwise. Tighten securely.
Installing a Pre Wound Reel
1.Hold the outer spool with one hand and unscrew the Bump Knob clockwise (Fig. 6). Inspect the bolt inside the Bump Knob to make sure it moves freely. Replace the Bump Knob if damaged.
2.Remove the old inner reel from the outer spool (Fig. 6).
3.Remove the spring from the old inner reel (Fig. 6).
4.Place the spring in the new inner reel.
NOTE: The spring must be assembled on the inner reel before reassembling the cutting attachment.
5.Insert the ends of the line through the eyelets in the outer spool (Fig. 12).
6.Place the new inner reel inside the outer spool. Push the inner reel and outer spool together. While holding the inner reel and outer spool, grasp the ends and pull firmly to release the line from the holding slots in the spool.
7.Hold the inner reel in place and install the Bump Knob by turning counterclockwise. Tighten securely.
Replacement Parts
For replacement parts, refer to the Accessories / Replacement Parts section.
Storage
•Store the unit locked up to prevent unauthorized use or damage.
•Store the unit in a dry,
•Store the unit out of the reach of children.
Long Term Storage
If the unit will be stored for an extended time, use the following storage procedure:
1.Thoroughly clean the unit and inspect it for any loose or damaged parts. Repair or replace damaged parts and tighten loose screws, nuts or bolts. The unit is ready for storage.
Transporting
• Secure the unit while transporting.
Accessories / Replacement Parts
Replacement Line Cartridge | |
Inner Reel Spring | 610636 |
Bump Head Knob Assembly | 180814 |
Shoulder Strap | 682075 |
6