SECTION 3: ASSEMBLING YOUR TRIMMER

On some units, the J-handle may be pre-installed, requiring only screw loosening and J-handle adjustment tailored to the operator. Go to step 6 to adjust the J-handle if it is pre-installed.

INSTALLING AND ADJUSTING THE J-HANDLE

Installing

1.Remove the screws, nuts, and top and middle clamp pieces that were installed on the J-handle for shipping.

2.Place the J-handle between the top and middle clamp pieces, Figure 1.

J-Handle

(4) Screws

Top Clamp

Middle Clamp

Bottom Clamp

Nuts

FIGURE 1

3.While holding the three pieces together, install the four (4) screws through the top clamp and into middle clamp.

NOTE: The holes in the top and middle clamp will line up only when assembled correctly.

4.Place the clamps and the J-handle over the shaft housing and onto the bottom clamp.

5.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.

Adjusting

6.Loosen the screws so that the J-handle can be easily moved in the clamp assembly. Do not remove the screws or nuts.

7.Slide the J-handle in or out until the arrow/white line on the decal touches the clamp assembly, Figure 2.

Decal

FIGURE 2

8.While holding the unit in the operating position, position the J-handle to the location that provides you the best grip, Figure 3.

9.Tighten the clamp screws evenly, until the J-handle is secure.

FIGURE 3

7