3
Attaching
Bracket
Assembly
Model Series 600
through 619
IMPORTANT:
Before assembly, place
the tractor on a firm,
level surface, disengage the PTO, stop the tractor engine and set the park- ing brake.
Attaching The Bracket
Assembly
Model Series 600 through 619
IMPORTANT: Before assembly, place the tractor on a firm, level surface, disengage the PTO, stop the tractor engine and set the parking brake.
1.For convenience, pivot the seat forward and leave it in that position until the grass collector is fully mounted and assembled.
2.Remove the hairpin clip and clevis pin from the rear of the mounting bracket assembly. See Figure 5.
3.Position the hooked ends of the bracket assembly over the shoulder bolts (1). Swing in the bottom of the bracket assembly down and in (2) over the hitch plate and aligning with the hole on the hitch plate. See Figure 5.
4.Reinsert the clevis pin through the aligned holes in both the bracket assembly and the hitch plate and secure with the hairpin clip removed earlier. Refer to Figure 6.
NOTE: There are two holes in the clevis pin. Be sure to insert the hairpin clip in the upper hole to properly secure the bracket assembly to the hitch plate.
Remove
Pin 
Hitch Plate 
Figure 5
NOTE:
There are two holes in the clevis pin. Be sure to insert the hairpin clip in the upper hole to properly secure the bracket assembly to the hitch plate.
Upper Hole
Figure 6
Model Series 650 through 699 This graphic below coordinates with the instructions for the Model Series 650 through 699, which begin on the next page.
Screws | Support |
Removed | Bracket |
Earlier |
|
Outer Hole | Outside of Bracket |
Figure 7 | Figure 8 |
6
