3
Setup And Adjustment
Contents of Carton
Carton contents are listed below with part numbers in parentheses.
1 1. Two Ignition Keys
2. 2.6 oz Bottle of 2 Cycle Oil
3. Extension Cord (if so equipped)
WARNING: Disconnect the spark plug
2wire and ground it against the engine to prevent unintended starting.
|
|
| Positioning the Upper Handle |
|
|
| 1. Remove packing material, if present. |
|
|
| 2. Making sure not to pinch the cable in the process, |
|
|
| pivot the upper handle into the operating position as |
|
|
| illustrated in Figure 1 until it clicks into place. |
| Figure 1 |
| 3. Tighten the wing knobs to secure the handle in place |
NOTE: This Operator’s |
|
| as in Figure 1. |
|
|
| |
Manual covers several |
|
| Assembling the Discharge Chute |
models. Snow thrower |
|
| For shipping reasons, the snow thrower has been |
features vary by | 2 |
| |
| packaged with the upper chute pivoted all the way down. | ||
model. Not all features |
|
| To pivot it upward, proceed as follows: |
discussed in this |
|
| 1. Turn the chute until the chute opening is facing |
manual are applicable |
|
| straight ahead. Remove the wing knob and carriage |
to all snow thrower |
|
| bolt from the lower chute. See Figure 2. |
models. |
| 3 | 2. Pivot the upper chute upward over the lip on the lower |
|
| chute so that there is NO gap between the upper | |
|
|
| |
NOTE: All references |
|
| chute and the lower chute. |
1 |
| 3. Resecure with the hardware just removed. If installed | |
to left or right side of |
| ||
| correctly, your snow thrower should look like Figure 3. | ||
the snow thrower is |
|
| |
|
| IMPORTANT: Do not use the chute handle to lift the | |
from the operating |
|
| |
|
| snow thrower. | |
position only. |
|
|
|
| Figure 2 |
|
|
IMPORTANT: |
|
|
|
Do not use the chute |
|
|
|
handle to lift the snow | Chute Handle |
|
|
thrower. |
|
|
Figure 3