5. Insert post on |
| 3 | |
cable tie into |
| ||
hole provided |
| ||
on the lower |
| ||
handle. Pull | A | ||
cable tie | |||
tight and trim |
| Setup and | |
|
| ||
excess. See |
| Adjustments | |
Figure |
| ||
|
| ||
| C |
| |
Figure | B |
| |
|
| ||
2 |
|
| |
1 | Figure | NOTE: Make certain | |
3 |
| ||
|
| bag is turned right side | |
|
| out before assembling | |
|
| (warning label will be on | |
|
| the outside). | |
| B | NOTE: Make certain | |
| A | cables are routed to the | |
|
| outside of the handle so | |
Figure |
| they are not in the way | |
| when attaching the grass | ||
|
| ||
6. Each wheel has a height adjustment lever to change |
| catcher. | |
the cutting height of the mower. To change the height |
|
| |
of cut, squeeze adjuster lever toward the wheel, |
|
| |
moving up or down to selected height. See Figure |
|
| |
7. To assemble the grasscatcher: |
|
| |
a. Place bag over frame (black plastic side is the | Figure |
| |
bottom of bag.) Insert the hooks on the frame |
| ||
|
| ||
through the holes in the side plastic channels of |
| WARNING | |
the bag. See Figure |
| ||
b. Secure bag to frame by working the plastic chan- | A | Never operate mower | |
nels on bag over frame as shown in Figure | |||
unless the hooks on | |||
of the plastic channels except center top of bag |
| ||
attach from the outside of bag. Center top of bag |
| the grass catcher are | |
attaches from the inside of bag. |
| firmly seated on the | |
8. Attaching Grass Catcher to Mower | B | pivot rod, and the | |
a. Lift the rear discharge door on the mower, and |
| rear discharge door | |
| rests firmly against | ||
place the grass catcher on the pivot rod. Let go |
| ||
| top of the grass | ||
of discharge door so that it rests on the grass |
| ||
| catcher. | ||
catcher. See Figure | Figure | ||
| |||
9. To remove grass catcher and utilize the mulching |
| ||
| All mowers are | ||
feature: | a. On the side of the mower deck, lift the hinged | ||
a. Lift rear discharge door on the mower as shown in | equipped with a rear | ||
mulching plug. See Figure | |||
protective guard. The | |||
Figure | b. Slide the two hooks on the side discharge deflec- | ||
pivot rod. Release rear discharge door to allow it to | guard helps eliminate | ||
tor under the hinge pin on the hinged mulching | |||
close rear opening of mower. | projectiles thrown | ||
plug assembly. Lower the hinged mulching plug. | |||
10. The side discharge is an optional feature. | by the blade from | ||
NOTE: Do not remove the hinged mulching plug at any | |||
injuring the operator. | |||
If converting to side discharge, make sure grass | |||
time, even when you are not mulching. | |||
catcher is off unit and rear discharge door is closed. | DO NOT REMOVE | ||
| |||
|
| THIS GUARD. |