OPERATING INSTRUCTIONS

ASSEMBLING THE COUPLER

The TrimmerPlus® system enables the use of these optional add-ons.

Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r

Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r

Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r

Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r

Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . . SB720r

Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . SS725r

Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r

Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r

WARNING: Read and understand operator’s manual for add-on prior to operation.

Removing the add-on:

1.Turn the knob counterclockwise to loosen (Fig. 7).

2.Press and hold the release button (Fig. 7).

3.While firmly holding the upper shaft housing, pull the tree pruner attachment out of the coupler (Fig. 8).

Installing the add-on:

WARNING: To avoid serious personal injury and damage to the unit, shut unit off before removing or installing add-ons.

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1.Turn knob counterclockwise to loosen (Fig. 7).

2.While firmly holding the add-on, push it straight into the coupler (Fig. 8).

Coupler

Guide Recess

 

Release Button

CounterclockwiseClockwise

Knob

Fig. 7

NOTE: Aligning the release button with the guide recess will help installation (Fig. 7).

Coupler

Release Button

 

 

Primary Hole

Upper Shaft

Lower Shaft

Housing

Housing

 

Knob

Fig. 8

3. Turn the knob clockwise to tighten (Fig. 9).

CAUTION: Lock the release button in the primary hole (Fig. 8) and securely tighten the knob before operating this unit.

Knob

Fig. 9

CAUTION: The tree pruner attachment with the coupler system is to be used in the primary hole only. Using the wrong hole could lead to personal injury or damage to the unit.

Installing the boom extension:

When using the boom extension, follow steps 1-3

under Installing the Attachment or Add-ons. Install the extension to the power head, then repeat the steps for installing the pruner attachment to the extension.

Check Flex Shaft Engagement Prior to Using

1.Start the unit.

2.Briefly engage and release the trigger.

3.Check that add-on is operating.

4.If the add-on is not operating, remove add-on and repeat steps for installing the add-on.

5.Recheck operation of add-on attachment.

7