18Reinstall threshold trim. Locate and align holes in vehicle with pins on trim.
19.Bolt seat bracket legs back down and put plastic bolt covers back
on.
For technical assistance call 1-800-CALL MTX.
These instructions are guidelines only and in no way are intended to replace a professional installation. As always before screwing or drilling check to make sure you will not damage any wires or hoses or cause damage to the vehicle.
Warning: Batteries normally produce explosive gases which can cause personal injury. Therefore, do not allow flames, sparks or lighted sub- stances to come near the battery. When charging or working near a battery, always shield your face and protect your eyes. Always provide ventilation
4Route 10ga red power wire from furnished wiring harness starting at
5Open hood.
6Drill a hole through the firewall. Locate a spot low on the firewall on the passenger's side. You should always look to find a clear path. Drill a hole from inside of the vehicle into engine compartment and insert grommet.
Drill Hole |
|
for Grommet | Firewall |
|
Battery
Note: To avoid any damage to parts inside engine compartment, drill from inside of vehicle using a short bit.
7Route 10ga red power wire through a grommet into the engine com- partment.
8Route 10ga red power wire through engine compartment safely away from any moving or hot parts that could damage the wire.
9Cut 10ga red power wire to length, connect the supplied fuse holder from the wire kit to the end of the wire.
1 0 Remove 20amp fuse from MTX fuse holder. Connect furnished ring terminal to positive side of battery. Remove 5/16" bolt from factory battery terminal. Pass bolt through factory battery terminal, then ring terminal, and into the other side of factory battery terminal and retighten bolt.
5 | 2 |
