MTX Audio MP41B, MP41W owner manual MP41 CONFIGURATION GUIDE, Bracket Mounting

MP41 CONFIGURATION GUIDE

BRACKET MOUNTING

MP41 CONFIGURATION GUIDE

BRACKET MOUNTING

B-STYLE CAP

BRASS

THUMB

SCREW

B-STYLE

CAP

ALUMINUM

BRACKET

BRASS

THUMB

SCREW

1)Remove the B-Type end caps, brass thumb screws, and aluminum mounting bracket.

2)Hold the bracket up to the desired mounting surface. Being careful to leave enough space for tightening the brass thumb screws and installing the B-Type end caps.

3)Use a level or measuring tape to insure that the bracket is square with its surroundings.

4)Mark the locations of the bracket mounting screw holes.

5)Drill pilot holes (if required) into the mounting surface.

6)Pull the speaker wire through the center hole in the bracket.

7)Attach the bracket to the mounting surface. Please Note: The MP41 weighs approximately 4 pounds, use only hardware that will support this type of load.

8)Slide the MP41 cabinet into the mounting bracket and secure with the two brass thumb screws.

9)Adjust the MP41 cabinet for the desired angle and tighten the thumb screws.

10)Attach the B-Type end caps by inserting the cap mounting tab into the slot in the back of the speaker baffle. Then snap the cap down onto the brass thumb screws.

7 8