MTX Audio MP42B/ MP42W Painting, Grill Assembly, MP42 CONFIGURATION GUIDE, Floor Stand

PAINTING

Carefully remove the spring clip on the back of the grill logo and remove the logo. Mask the baffle area of the speaker cabinet out to the grill mounting groove. If you are going to mount the MP42 using the supplied wall bracket it is best to also mask off the foam rubber bracket gaskets at the top and bottom of the speaker cabinet. Almost any type of paint can be used but best results will be had using a quick drying enamel or lacquer spray paint. For best results always follow the paint manufacturers recommendations for proper application. After painting the cabinet, grill and applicable end caps allow the paint to dry thoroughly.

GRILL ASSEMBLY

Place the four grill adhesive strips in the groove located at the outer rim of the baffle. Carefully snap the grill into place and rotate the logo for proper orientation.

MP42 CONFIGURATION GUIDE

FLOOR STAND

Remove the B-Type end caps, brass thumb screws, and aluminum mounting bracket. Replace the brass thumb screws in the top of the cabinet and snap an A-Type end cap into place. Then simply mount the MP42 to the recommended Studio Tech S1 stands using a 1/4-20 1” long hex head bolt. (Not Included)

A-TYPE

CAP

STUDIO TECH

S1 STANDS

RECOMMENDED

1/4-20

1” LONG

BOLT

9 6