Multi-Link ACP-300

When programming this register, you must enter all Flag (Bit) values. The

flags are preset to the following: Flag 1 (Bit 3) Device 4 Barge-in Mask 0 (off)

Flag 2 (Bit 2) Device 3 Barge-in Mask 0 (off)

Flag 3 (Bit 1) Device 2 Barge-in Mask 0 (off)

Flag 4 (Bit 0) Device 1 Barge-in Mask 0 (off)

This register contains the amount of time that a telephone receiver must be held

off-hook to "barge-in" on a call. The range of this register is 0 (off) to 15 with a 2

second multiplier for each digit. Factory preset to 0 (off).

This register contains the number of minutes that the ACP will accept the

programming code once power has been applied to the unit. The range of this

Factory preset to 0 (allows programming at all times).

This register contains the maximum number of seconds the ACP will hold the

phone line, during a multiple polling sequence after a device has been

disconnected. This register ranges from 10 to 99. Factory preset to 25 (no ring

back is provided to caller during this time).

(Note: ACP-9 utilizes Registers 11-15 plus 26-29. ACP-5 uses Registers 11-

15, and ACP-3 utilizes Registers only 11-13 for Device Codes.

Contains the security access code for device port 1. This register holds up to 7

digits ranging from 0 to 9, * and #. Factory preset to 11.

Contains the security access code for device port 2. This register holds up to 7

digits ranging from 0 to 9, * and #. Factory preset to 22.

Contains the security access code for device port 3. This register holds up to

digits ranging from 0 to 9 ' and #. Factory preset to 33

Contains the security access code for device port 4. This register holds up to 7

digits ranging from 0 to 9, " and #. Factory preset to 44.