Chapter 2 – Operation
Chapter 2 – Operation
Front Panel
The MT2834ZDX has ten LED indicators on the front panel that indicate status, configuration, and activity:
Transmit Data. The TD LED lights when the modem is transmitting data to another modem. The state of the LED matches the TD circuit on pin 2 of the
Receive Data. The RD LED lights when the modem is receiving data from another modem. The state of the LED matches that of the RD circuit on pin 3 of the
Carrier Detect. The CD LED lights when the modem detects a valid carrier signal from another modem. It is on when the modem is communicating with the other modem and off when the link is broken.
33,600 bps. The 33 LED lights by itself when the modem connects 33,600 bps operation. This LED also lights or blinks in combination with the 14 LED to indicate speeds between 16,800 and 26,400 bps (see table).
14,400 bps. The 14 LED lights by itself when the modem connects at 14,400 bps. The 14 LED lights or blinks in combination with the 28 LED to indicate speeds between 16,800 and 26,400 bps. It lights together with the 96 LED to indicate a speed of 12,000 bps.
9600 bps. The 96 LED lights when the modem connects at 9600 bps. If no speed LED lights, the modem is operating at less than 9600 bps.
Terminal Ready. The TR LED lights when a datacomm program initializes the modem. It means the modem is ready for an outgoing or incoming call. It goes off when the datacomm program disconnects the COM port. When it goes off, a connected modem will disconnect. The state of the TR LED matches that of the DTR circuit on pin 20 of the RS- 232C/V.24 interface.
Error Correction (V.42). The EC LED lights continuously when the modem is in error correction mode, and blinks when compression is activated.
Fax. The FX LED lights when the modem is in fax mode.
Note: When you turn on the MT2834ZDX, the speed lights flash briefly as the modem does a
Speed Indicator Blink Rates
The 33, 14, and 96 speed indicators light singly or in combination to indicate data rates.
7 |
