Chapter 3 - Using the Front Panel
The following screens are used to configure remote configuration options. For more information about remote configuration, see Chapter 5, “Remote Configuration.”
ENABLE/DISABLE R.C. Use the ◊ and Enter buttons to turn remoteconfiguration on or off.
| REMOTE CONFIG. PASSWORD. Use to enter the remote con- |
| figuration password. To scroll through a list of digits and charac- |
| ters, press the 〈⇓ and buttons. To go to the next position, |
| press the ◊ button. To back up or to exit without saving, press |
| the ◊ button several times. To save the password, press the |
Enter button. |
Use the following screens to turn loopback tests on and off. For information about how to apply these tests, see Appendix C, “Loopback Tests.”
ANALOG LOOPBACK. Press the ◊ and Enter buttons to start the analog loopback test. The TEST IN PROGRESS screen appears. To stop the test, press the ◊ and Enter buttons again.
DIGITAL LOOPBACK. Press the ◊ and Enter buttons to start the local digital loopback test. The TEST IN PROGRESS screen appears. To stop the test, press the ◊ and Enter but- tons again. Same as the &T3 command.
REMOTE DIGITAL LOOPBACK. Press the ◊ and Enter but- tons to start the remote digital loopback test. The TEST IN PROGRESS screen appears. To stop the test, press the ◊ and
!"Enter buttons again. Same as the &T6 command.
Use the following screens to list, enter, and dial stored phone numbers. Up to four phone numbers can be stored. The number in memory location 0 is used for DTR dialing, if DTR dialing is enabled. Note: Only 16 characters can be displayed at a time. To display characters
LIST PHONE NUMBERS. Press the ◊ button several times to display the phone number stored in each memory location.
ENTER PHONE NUMBERS. Use to store up to four phone num- bers in memory locations
DIAL STORED NUMBERS. Press the ◊ and Enter buttons to dial a stored phone number. Same as the DS= commands.
| 27 |
|
