MultiModemZPX User Guide | 3 Using Your Modem |
Setup
Changing the Setup Password
Caution: You can only change the setup password locally; you cannot do it remotely.
1.Open a data communications program such as HyperTerminal.
2.In the terminal window, type AT#SMTSMODEM (or AT#Syyyyyy if you have replaced the MTSMODEM password with yyyyyy) and press Enter. The modem responds with OK if the setup password is correct and ERROR if it is wrong.
3.To change the password, type AT#S=yyyyyy, where yyyyyy is the password, and press Enter. The password can include any keyboard character and must be one to eight charac- ters long. The modem responds with OK.
4.The new password is saved automatically. You now can enter more AT commands or exit the data communications program. The next time you remotely configure the modem you must use the new setup password.
Changing the Remote Escape Character
To increase security, you can change a remote modem’s remote configuration escape character. The remote configuration escape character is stored in register S9. The factory default is 37, which is the ASCII code for the percent character (%). For more information on ASCII codes, refer to Appendix D.
1.Establish a remote configuration link with the remote modem as described in Basic Procedure on the previous page.
2.Type ATS9=n, where n is the ASCII code for the new remote configuration escape character. Then press ENTER.
Caution: Setting S9 to 0 (zero) disables remote configuration
3.To save the new value, type AT&W and press Enter.
4.Type ATO, then Enter to exit remote configuration.
21
