Multi-Tech Systems MT9234ZPX-UPCI-NV manual Configuration

Appendix D – Installing under Linux

This will bring minicom into configuration mode. You should get a response like this:

[root@armadillo ~]# minicom -s

minicom: WARNING: configuration file not found, using defaults From the configuration menu, select “Serial Port Setup” and press Enter.

Configuration

Filenames and paths

File transfer protocols

Serial port setup

Modem and dialing

Screen and keyboard

Save setup as dfl

Save setup as..

Exit

Exit from Minicom

This will display the Serial port settings.

A - Serial Device	: /dev/modem
B - Lockfile Location	: /var/lock
C - Callin Program	:
D - Callout Program	:
E - Bps/Par/Bits	: 38400 8N1

F - Hardware Flow Control : Yes

G - Software Flow Control : No

Change which setting?

Enter A to edit the Serial Device. Then enter the port you need to access.

As shown above the ports of interest will be :

0000:03:00.0: ttyS0 at MMIO 0xcdeffc00 (irq = 169) is a 16550A

0000:03:00.0: ttyS2 at MMIO 0xcdeffe00 (irq = 169) is a 16550A

In this case, you want to access the first port “ttyS0”.

A - Serial Device	: /dev/ttyS0
B - Lockfile Location	: /var/lock
C - Callin Program	:
D - Callout Program	:
E - Bps/Par/Bits	: 38400 8N1

F - Hardware Flow Control : Yes

G - Software Flow Control : No

Change which setting?

Press Enter to accept the change. To change any other setting, press the corresponding key. However, the modem should respond with the rest of the default settings in minicom.

Multi-Tech Systems, Inc. MT9234ZPX User Guide 59