EM-900SDCE MIXER — ENGINE COMPONENTS
Figure 1. Basic Engine Components
INITIAL SERVICING
The engine (Figure 1) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the manufacturers Engine manual for instructions & details of operation and servicing.
1. Fuel Filler Cap/Fuel tank – Pull this latch to add diesel fuel to the tank. After refueling, always make sure the fuel cap is latched properly. DO NOT over fill. For additional information refer to engine owner's manual.
6.Engine Motor Mounts – Attach these engine mounts to the mixer frame.Tighten securely.
7.Oil Filter – Remove this bolt to gain access (internal) to the engine oil filter. Service the oil filter as recommended in the maintenance section of this manual.
8.Oil Drain Plugs – There are two oil drain plugs, one is underneath the flywheel, the other on the side of the engine. Remove these plugs to drain engine oil from the engine.
DANGER
Adding fuel to the tank should be accomplished only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.
2. Engine Lifting Straps/Cover – Remove the air cleaner cover, then lift this cover (the one with decals on it) to gain access to the engine lifting straps.
3. Air Cleaner/Cover – Prevents dirt and other debris from entering the fuel system. Remove
4. Speed Control Lever – This lever is connected to the throttle control which is located on the side of the engine compartment cover. Use this lever to control engine speed.
5.Dip Stick – Remove dipstick to determine if the engine oil level is low. If low add oil as specified in Table 4, page 18.
9.Crankshaft – Connect this shaft to the input of the transmission.
10. Muffler – Used to reduce noise and emissions.
11. Nameplate – Contains information about the engine.
WARNING
Enginecomponentscangenerateextremeheat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.
Operating the engine without an air filter, with a damaged air filter, or a
NOTE filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.
MULTIQUIP
