EM-900SDCE MIXER — INSPECTION
See Figures 1 and 2 (Pages 11 and 12) for the location of any control or component referenced in this manual.
FUEL
1.Lift the fuel cap latch (Figure 1) located on top of the fuel tank, then look inside the tank and determine if the engine fuel is low . If fuel is low, fill with diesel fuel (Figure 4).
CAUTION
Handle fuel safely. Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel mixer if the engine is hot or running. ALWAYS allow engine to cool before refueling.
Figure 4. Fuel Tank
ENGINE OIL
1.Remove the engine oil dipstick from its holder (Figure 5).
Figure 5. Oil Filler Port/Dipstick
2.Determine if the engine oil is low (Figure 6), add correct amount of engine oil to bring oil level to a normal safe level. See Table 4 for recommended oil type.
Figure 6. Dipstick
ZERK GREASE FITTINGS
1.Check the zerk grease fittings at each end of the mixing drum (Figure 7).These grease fittings lubricate the dumping mechanism. If the dumping handle is stiff or hard to move lubricate these fittings.
Figure 7. Zerk Fittings (Bearings)
PAGE 16 — MULTIQUIP
