FS2 CONCRETE SAW — RULES FOR SAFE OPERATION
GENERAL SAFETY
■Always read, understand, and follow procedures in Operator’s Manual before attempting to operate equipment.
■Always be sure the operator is familiar with proper safety precautions and operating techniques before using the saw.
■Stop the engine when leaving the saw unattended.
■Block the unit when leaving or when using on a slope.
■Maintain this equipment in a safe operating condition at all times.
■Always stop the engine before servicing, adding fuel and oil.
■NEVER Run engine without air filter. Severe engine damage may occur.
■Always service air cleaner frequently to prevent carburetor malfunction.
■Always store equipment properly when it is not being used. Equipment should be stored in a clean, dry location out of the reach of children.
■NEVER use accessories or attachments, which are not recommended by Multiquip for this equipment. Damage to the equipment and/or injury to user may result.
■NEVERoperatethissawinareasthatcontaincombustiblematerial or fumes. Fire and/or explosions may result from errant sparks from the equipment.
WARNING:
■DO NOT operate this equipment unless all guards and safety devices are attached and in place.
■Caution must be exercised while servicing this equipment. Rotating and moving parts can cause injury if contacted.
■Keep all inexperienced and unauthorized people away from the equipment at all times.
■Unauthorized equipment modifications will void all warranties.
■Test the ON/OFF switch before operating.The purpose of the switch is to shut down the engine.
DIAMOND BLADE SAFETY
■Use appropriate steel centered diamond blades manufactured for use on concrete saws.
■Always inspect diamond blades before each use. The blade should exhibit no cracks, dings, or flaws in the steel centered core and/or rim. Center (arbor) hole must be undamaged and true.
■Examine blade flanges for damage, excessive wear and cleanliness before mounting blade. Blade should fit snugly on the shaft and against the inside/outside blade flanges.
■Ensure that blade is marked with an operating speed greater than the blade shaft speed of the saw.
■Only cut the material that is specified by the diamond blade. Read the specifications of the diamond blade to ensure the proper tool has been matched to the material being cut.
■Always keep blade guards in place. Exposure of the diamond blade must not exceed 180 degrees.
■Ensure that the diamond blade does not come into contact with the ground or surface during transportation. DO NOT drop the diamond blade on ground or surface.
■The engine governor is designed to permit maximum engine speed in a
■Ensure that the blade is mounted for proper operating direction.
SAW TRANSPORTATION SAFETY
■Use the lifting bail and appropriate lifting equipment to ensure the safe movement of the saw.
■DO NOT use the handle bars and/or front pointer as lifting points.
■NEVER tow the saw behind a vehicle.
■Ensure that both pointer bars are positioned appropriately to minimize their exposure during transportation.
■Safeguard against extreme saw attitudes relative to level. Engines tipped to extreme angles may cause oil to gravitate into the cylinder head making the engine difficult to start.
■NEVER transport the saw with the blade mounted.
PAGE 10 —
