CAUTION :

When using a combination of dual receptacles, total load should not exceed the rated capacity of the generating.

Power Outlets

The generator has the following 120/240 volt 60 Hz (single- phase) receptacles.

zSingle Phase

One Duplex NEMA (GFCI) 5-20R (120V, 20 Amp) One Twist Lock NEMA L5-30R (120V, 30 Amp)

One Twist Lock NEMA L6-20R (240V, 20 Amp)

Main Circuit Breaker (2-Pole 120/240V 60 Hz)

This 2-pole 21 amp breaker protects the generator from short circuiting or overloading from the 120/240V 60 Hz single phase load.

Idle Control Switch

This unit is provided with an automatic idle control for noise suppression and reduced fuel consumption. The automatic idle control automatically engages under a no-load condition. With the automatic idle control switched “ON”, the engine revolutions will automatically drop to about 2500 rpm (low- speed operation) within 3 seconds after the load stops.When the operation is resumed, the engine speed is automatically increased to about 3600 rpm (high-speed operation) as soon as the load is connected.

Fuel Gauge

The fuel gauge is located on the fuel tank and allows easy monitoring of the fuel level.

ACVoltmeter

This voltmeter indicates (with a mark) the rated 60 Hz, single phase output voltage. In addition the voltmeter can also be used as a diagnostic tool.

If the voltmeter indicator (needle) is below the rated voltage, engine problems may exist (low/high RPM's). To prevent damage to the generator or power tools turn the generator OFF and consult your authorized Multiquip service dealer.

Operation Switch

This switch must be in the ON position (up) for normal operation.

GA-6HZ— INSTRUMENTATION

Start Switch

Push this switch to start the engine (electric start only). If a recoil starter is used, pull the starter rope to start the engine. Make sure the operation switch is in the ON position (up), otherwise engine will not start.

Full Power Switch

The unit is provided with a full power switch. Figures 2 and 3 show simplified wiring diagrams of the dual voltage system.

When the full power switch is in the 120 volt (up) position, you can take up full rated power of the generator at 120 volts from the single duplex receptacle, single locking type 120 volt receptacle, or a combination of these receptacles as long as the total load does not exceed the generating set capacity.

Figure 2. 120 V Simplified Diagram (Switch Up)

NOTE

When the full power switch is in the 120 volt position, the locking type 240 volt receptacle cannot be used.

When the full power switch is in the 240 volt (down) position, you can take up to half of the rated power of the generating set at 120 volts from the duplex receptacle and up to half of the rated power of the set at 120 volts from the locking type 120 volt receptacle; or full rated power of the set at 240 volts from the locking type 240 volt receptacle.

Figure 3. 120/240V Simplified Diagram (Sw Dn.)

PAGE 14 — GA-6HZ A.C. GENERATOR — PARTS & OPERATION MANUAL — REV. #4 (10/08/04)

Page 14
Image 14
Multiquip operation manual GA-6HZ- Instrumentation, Power Outlets, Start Switch, Full Power Switch

GA-6HZ specifications

The Multiquip GA-6HZ is a robust and versatile generator designed for reliability and efficiency in various applications. Known for its powerful performance, the GA-6HZ is widely used in construction, events, and other high-demand environments where a consistent power supply is crucial.

One of the standout features of the GA-6HZ is its impressive engine, powered by a reliable Honda GX390. This air-cooled engine boasts a powerful output, providing ample power for a wide range of tools and equipment. The sturdy construction of the generator ensures it can withstand harsh job site conditions while delivering exceptional performance.

The GA-6HZ is equipped with a 6 kW maximum output, making it suitable for powering multiple devices simultaneously. The generator features both 120V and 240V outlets, allowing for versatile applications. The inclusion of a duplex outlet and a twist-lock outlet further enhances its usability, making it capable of meeting various power demands.

In terms of technology, the GA-6HZ employs a sophisticated alternator design that minimizes voltage fluctuations, ensuring stable power delivery even under varying loads. The generator also features an automatic voltage regulator (AVR) that enhances the efficiency and consistency of operation. This technology contributes significantly to the generator’s reliability, as it protects sensitive electronics from fluctuations that could cause damage.

Portability is another key characteristic of the GA-6HZ. It is designed with a compact footprint and features built-in lifting handles, making transportation to and around job sites convenient. Additionally, the generator is equipped with a large fuel tank that allows for extended run times, further minimizing downtime during crucial projects.

Another notable characteristic is its user-friendly control panel. The GA-6HZ features clearly labeled controls and gauges, allowing operators to monitor performance easily. The generator also has multiple safety features, including a low oil shutdown, ensuring that it operates smoothly without risking damage or safety hazards.

In summary, the Multiquip GA-6HZ stands out as a highly reliable and efficient generator, suitable for various demanding applications. With a powerful engine, versatile output options, advanced technology, and user-friendly features, it remains a popular choice among professionals seeking dependable power solutions.