Multiquip GX12061 manual MVC-64VH/VHW Inspection, Before Starting, Engine Oil Check, Fuel Check

Before Starting

1.Read safety instructions at the beginning of manual.

2.Cleanthecompactor,removingdirtanddust.Particularly,the bottom of the plate, engine cooling air inlet, carburetor and air cleaner.

3.Check theair filterfor dirtand dust.If theair filterisdirty,blow through the air filter cartridge from the inside, moving a jet of dry compressed air up and down until all dust is removed. Otherwise replace air filter with a new one.

4.Check carburetor for external dirt and dust. Clean with dry compressedair.

5.Check fastening nuts and bolts for tightness. Loosened screws or bolts due to vibration, could lead to unexpected accident.

Engine Oil Check

1.To check the engine oil level, place the plate compactor on secure level ground with the engine stopped.

2.Remove the filler cap/dipstick from the engine oil filler hole (Figure 5) and wipe it clean.

Figure 5. Engine Oil Dipstick

3.Insertandremovethedipstickwithoutscrewingitintothefiller neck. Check the oil level shown on the dipstick.

4.If the oil level is low (Figure 6), fill to the edge of the oil filler hole with the recommended oil type (Table 4).

UPPER LIMIT

LOWER LIMIT

Figure 6. Engine Oil Dipstick

MVC-64VH/VHW — INSPECTION

The Oil Alert system will automatically stop the engine

NOTE	before the engine falls below safe
	limits. Always be sure to check
	the engine oil level prior to starting
	the engine.
	Table 4. Oil Type
Season	Temperature	Oil Type
Summer	25°C or Higher	SAE 10W-30
Spring/Fall	25°C~10°C	SAE 10W-30/20
Winter	0°C or Lower	SAE 10W-10

Danger - Flammable Fuel

Motor fuels are highly flammable and can be dangerous if mishandled. DO NOT smoke while refueling. DO NOT attempt to refuel the compactor if the engine is hot! , running or in the dark.

Danger - Flammable Fuel

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunitytocooldown. Intheeventofafuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

Fuel Check

1.Remove the gasoline cap located on top of fuel tank.

2.Visually inspect to see if fuel level is low. If fuel islow, replenish with unleaded fuel.

3.Whenrefueling,besuretouseastrainerforfiltration.DONOT top-off fuel. Wipe up any spilled fuel.

Caution - Spilled Fuel

Since spilled fuel could ignite if it comes into contact with hot engine parts, ALWAYS pour fuel from the recoil starter side of the compactor.Allow engine to cool! before refueling.Wipe up any spilled fuel immediately.

PAGE 16 — MVC-64VH/VHW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #1 (03/01/07)