MVC-64VH/VHW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #1 (03/01/07) — PAGE 17
2. The V-belt tension is proper if the V-belt bends 10 to 15 mm
(Figure 10) when depressed with finger at midway between
the clutch and vibration pulley shafts.
MVC-64VH/VHW — INSPECTION

CLUTCH

PULLEY

VIBRATOR

PULLEY

Figure 7. V-Belt Hazard
1. To check the V-belt tension, remove the bolts that secure the
belt cover to the frame as shown in Figure 8.
Figure 8. V-Belt Cover Removal
3. A loose V-belt will decrease the power transmission output,
causing reduced compaction and premature wear of the
belt.
4. If the V-belt becomes worn or loose, replace it .
Figure 9. V-Belt Tension
Vibrator Oil Check
1. Place the MVC-64VH/VHW plate compactor horizontally on
a flat surface. Make sure the compactor is level when check-
ing the oil in the vibrator assembly.
2. Check vibrator oil level by removing the plug (vibrator oil gauge)
as shown in Figure 10. The oil level should be up to the oil plug.
If oil is required, replace using only SAE 10W-30 motor oil.
Figure 10. Vibrator Oil Plug
NEVER attempt to check the V-belt with the engine running.
Severe injury can occur if your hand (Figure 7) gets caught
between the V-belt and the clutch. Always use safety gloves.

Caution - V-Belt check

V-Belt Check