10
5
6 
components
3
2
4
1
9
11
712
8 | 13 |
|
Figure 1. MTX80SD Rammer
Figure 1 shows the location of the controls and components for the MTX80SD Tamping Rammer.The functions of each control is described below:
1.Combination (Throttle) Lever — Used to adjust engine speed (rpm). Move lever forward (SLOW) to reduce engine speed, move lever back toward operator (FAST) to increase speed. Always operate the rammer at full speed (rpm).
2.Handle — To operate rammer, GRIP handle assembly firmly on both sides.
3.Fuel Tank Cap — Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.
4.Hook — Used to lift rammer for transporting.
5.Air Cleaner Cover — Protects the air cleaner which prevents dirt and other debris from entering the engine.
6.Roller — Allows rammer to be moved around easily by rolling the unit.
7.Bellows — Reservoir for oil bath.
8.Foot — Laminated wood with tempered steel plate for superior shock absorption.
9.Fuel Tank — Holds the fuel for the unit (up to 2.7 quarts).
10.Muffler — Reduces the noise of the engine when running.
11.Engine — This unit uses a Robin ER120D45000 gasoline engine.
12.Oil Gauge (Sight Glass) — Indicates the level of oil in the oil bath reservoir.
13.Drain Valve — Open this valve to remove oil from the bellows.
WARNING
Adding fuel to the tank should be accomplished only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the
fuel residue has been completely wiped up, and the area surrounding the engine is dry.
page 12 — MTX80SD RAMMER • operation and parts manual — rev. #0 (07/20/12)
