Multiquip MTX80SD manual Troubleshooting engine

Models: MTX80SD

1 58
Download 58 pages 28.71 Kb
Page 18
Image 18

 

 

troubleshooting

 

 

 

 

 

 

 

 

 

Troubleshooting (engine)

 

 

Symptom

possible problem

 

Solution

 

 

 

 

 

Combo lever in incorrect position?

 

Make sure combo lever is in start position.

 

 

 

 

 

Spark plug bridging?

 

Check gap, insulation or replace spark plug.

 

 

 

 

 

Carbon deposit on spark plug?

 

Clean or replace spark plug.

 

 

 

 

 

Short circuit due to defi cient spark plug

 

Check spark plug insulation, replace if worn.

 

insulation?

 

 

 

 

 

 

 

 

 

Improper spark plug gap?

 

Set to proper gap.

 

 

 

 

 

Fuel reaching carburetor?

 

Check fuel line.

 

 

 

 

 

Water in fuel tank?

 

Flush or replace fuel tank.

 

 

 

 

Diffi cult to start, fuel is available, but no spark at

Fuel fi lter clogged?

 

Replace fuel fi lter.

spark plug.

Stuck carburetor?

 

Check fl oat mechanism.

 

 

 

 

 

 

 

Spark plug is red?

 

Check transistor ignition unit.

 

 

 

 

 

 

 

If insuffi cient compression, repair or replace

 

Spark plug is bluish white?

 

engine. If injected air leaking, correct leak. If

 

 

 

carburetor jets clogged, clean carburetor.

 

 

 

Check transistor ignition unit is broken, and

 

No spark present at tip of spark plug?

 

replace defective unit. Check if voltage cord

 

 

cracked or broken and replace. Check if spark

 

 

 

 

 

 

plug if fouled and replace.

 

 

 

 

 

No oil?

 

Add oil as required.

 

 

 

 

 

ON/OFF switch is shorted?

 

Check switch wiring, replace switch.

 

 

 

 

Diffi cult to start, fuel is available, and spark is

Ignition coil defective?

 

Replace ignition coil.

 

 

 

Improper spark gap, points dirty?

 

Set correct spark gap and clean points.

present at the spark plug.

 

 

 

 

Condenser insulation worn or short circuiting?

 

Replace condenser.

 

 

 

 

 

 

 

Spark plug wire broken or short circuiting?

 

Replace defective spark plug wiring.

 

 

 

 

 

Wrong fuel type?

 

Flush fuel system, replace with correct type of

 

 

fuel.

 

 

 

Diffi cult to start, fuel is available, spark is

 

 

 

Water or dust in fuel system?

 

Flush fuel system.

present and compression is normal.

 

Air cleaner dirty?

 

Clean or replace air cleaner.

 

 

 

 

 

 

 

Choke open?

 

Close choke.

 

Suction/exhaust valve stuck or protruded?

 

Reseat valves.

 

 

 

 

Diffi cult to start, fuel is available, spark is

Piston ring and/or cylinder worn?

 

Replace piston rings and/or piston.

 

 

 

Cylinder head and/or spark plug not tightened

 

 

present and compression is low.

 

Torque cylinder head bolts and spark plug.

properly?

 

 

 

 

 

 

 

 

 

Head gasket and/or spark plug gasket damaged?

 

Replace head and spark plug gaskets.

 

 

 

 

 

No fuel in fuel tank?

 

Fill with correct type of fuel.

 

Fuel cock does not open properly?

 

Apply lubricant to loosen fuel cock lever,

 

 

replace if necessary.

No fuel present at carburetor.

 

 

 

 

 

Fuel fi lter/lines clogged?

 

Replace fuel fi lter.

 

 

 

 

 

 

 

Fuel tank cap breather hole clogged?

 

Clean or replace fuel tank cap.

 

 

 

 

 

Air in fuel line?

 

Bleed fuel line.

 

 

 

 

page 18 — MTX80SD RAMMER • operation and parts manual — rev. #0 (07/20/12)

Page 18
Image 18
Multiquip MTX80SD manual Troubleshooting engine