MVC-64H/HW — INITIAL START-UP/OPERATION
6.If the engine has started, slowly return the choke lever (Figure 13) to the CLOSED position. If the engine has not started repeat steps 1 through 5.
7.Beforethecompactorisputintooperationruntheenginefor
8.Check for abnormal engine noises or fuel leaks.
Stopping The Engine
Normal Shutdown
1.Move the throttle lever to the IDLEposition (Figure 17) and run the engine for three minutes at low speed.
Caution - Stopping Engine
NEVER stop the engine suddenly while working at high speeds.
1.Place the throttle lever (Figure 14) in slow position, and listen for the engine speed to decrease.
2.Place the Engine ON/OFF switch (Figure 12) in the "OFF " position.
3.Place the fuelvalvelever(Figure 11) in the "OFF" position.
Emergency Shutdown
1.Move the throttle lever quickly to the SLOW position, and place the engine ON/OFF switch in the OFF position.
Operation
CAUTION - Safety Rules
Make sure to follow all safety rules referenced in the safety sectionofthismanualbeforeoperatingcompactor. Keepwork area clear of debris and other objects that could cause damage to the compactor or bodily injury.
1.Once the engine has started, move the engine throttle lever quickly to the fast position.
2.With the throttle lever in the fast position, the engine speed should be around 2,300 RPM, therefore engaging the cen- trifugal clutch.
Always move the throttle lever quickly without hesitation, because
NOTE increasing the engine speed slowly causes the clutch to slip.
3.Firmlygaspthecompactor'shandlebar withbothhands,the compactor will begin moving forward.
4.Slowly walk behind the compactor and be on the lookout for anylargeobjectsorforeignmatterthatmightcausedamage to the compactor or bodily injury.
5.Compactortravelingspeedmaydroponsoilswhichcontain clay, however there may be cases where traveling speed drops because the compaction plate does not leave the ground surface easily due to the composition of the soil.To rectify this problem do the following:
z Check the bottom plate to see if clay or equivalent material has been lodged in the plate mechanism. If so, wash with water and remove.
z Remember the compactor does not work as efficiently on clay or soils that have a high moisture content level. z If the soil has a high moisture level, dry soil to appropriate moisture content level or carry out compaction twice.
