Multiquip MVC-64HW manual Changing Vibrator Oil, Checking and Replacing the V-Belt and Clutch

Figure 16. Engine Oil Plug

Air Filter

1.The air filter element should be cleaned because a clogged air cleaner can cause poor engine starting, lack of power and shorten engine life substantially.

2.To clean or replace air filter loosen the wing nut on the air filter housing (Figure 17), remove the cover and take out air filter cartridge. If only cleaning of the air filter is desired blow through the air filter cartridge from the inside, moving a jet of dry compressed air up and down until all dust is removed.

Figure 17. Air Filter

Spark Plug

1.Remove and clean the spark plug (Figure 18).

2.Adjust the spark gap to 0.028 ~0.031 inch (0.6~0.7 mm).This unit has electronic ignition, which requires no adjustments.

MVC-64H/HW — MAINTENANCE

Changing Vibrator Oil

1.When changing the vibrator oil, remove the drain plug (Figure 10), and simply tip the compactor to drain the oil. Note that the oil will drain more easily while it is hot. Remember to use only 10W-30 motor oil when replacing vibrator oil.

Checking and Replacing the V-Belt and Clutch

1.After 200 hours of operation, remove the upper belt cover to check the V-belt tension.Tension is proper if the belt bends about 10 mm when depressed strongly with finger between shafts. Loose or worn V-belts reduces power transmission efficiency, causing weak compaction and reduces the life of the belt itself.

zReplacing the V-belt

Remove the upper and lower belt covers. Engage an offset wrench (13 mm) or the like to vibrator pulley (lower) fastening bolt. Engage waste cloth or the like at midway of V-belt on the left side and while pulling it back strongly, rotate the offset wrench clockwise so that the V-belt will come off.

zReinstalling the V-belt

Engage V-belt to lower vibrator pulley and push the V-belt to left side of upper clutch and, in the same manner as in removal, rotate offset wrench clockwise so that the V-belt goes back on.

zChecking Clutch

Check the clutch simultaneously with V-belt checking. With belt removed, check outer drum of the clutch for seizure and "V" groove for wear or damage with your eyes. Clean the "V" groove as necessary. Wear of lining or shoe should be checked with running check. If the shoe is worn, power transmission becomes deficient and slipping will result.

WARNING - V-belt Hazard

NEVER attempt to check theV-belt with the engine running. Severe injury can occur if your hand (Figure 7) gets caught between theV-belt and the clutch.Always use safety gloves.

CAUTION - Vibration Check

Whenever the compactor's vibration becomes weak or lost duringnormaloperationregardlessofoperationhours,check theV-belt and clutch immediately.

Figure 18. Spark Plug Gap

MVC-64H/HW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #5 (03/01/07) — PAGE 21