Multiquip MVC-88VGE/VGEW- INITIAL START-UP, Nnnn, Fast Slow, Open, Closed, Fuel Valve Lever

MVC-88VGE/VGEW— INITIAL START-UP

CAUTION

DO NOT attempt to run the compactor until the Safety and Initial Start-upsectionshave been read and understood.

1. Place the fuel valve lever (Figure 9) in the "ON" position.

FUEL

LEVER

Figure 9. Fuel Valve Lever

2.Place the Engine ON/OFF switch (Figure 10) in the "ON" position.

ENGINE
ON/OFF
SWITCH	OFF

ON

The CLOSED position of the

NOTEchoke lever enriches the fuel mixture for starting a COLD engine. The OPEN position provides the correct fuel mixture for normal operation after starting, and for restarting a warm engine.

4.Place the throttle lever (Figure 12) halfway between fast and slow.

THROTTLE

LEVER

FAST SLOW

Figure 12. Throttle Lever

5.Grasp the starter grip (Figure 13) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingthecompressionpoint.Rewindtheropealittlefrom that point and pull out sharply.

Figure 10. Engine ON/Off Switch

3. Place the Choke Lever (Figure 11) in the "OPEN" position.

CAUTION

DO NOT pull the starter rope all the way to the end

DO NOT release the starter rope after pulling. Allow it to rewind as soon as possible.

CHOKE LEVER

Nnnn

OPEN

CLOSED

STARTER GRIP

Figure 11. Choke Lever

Figure 13. Starter Grip

MVC-88VGE/VGEW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #1 (01/11/11) — PAGE 17