Multiquip MVC-88VGE/VGEW- MAINTENANCE, Air Cleaner CHANGING VIBRATOR OIL, Replacing the V-belt

Models: MVC-88VGE/VGEW

1 64
Download 64 pages 48.61 Kb
Page 21
Image 21
Figure 15. Air Cleaner

MVC-88VGE/VGEW— MAINTENANCE

Figure 15. Air Cleaner

CHANGING VIBRATOR OIL

1.When changing the vibrator oil, remove the drain plug located at the bottom- right of the vibrator (Figure 8), and simply tip the compactor to drain the oil. Note that the oil will drain more easily while it is hot. Remember to use only 10W-30 motor oil when replacing vibrator oil.

Checking and Replacing the V-Belt and Clutch CAUTION

NEVER attempt to check theV-belt with the engine running. Severe injury can occur if your hand (Figure 5) gets caught between theV-belt and the clutch.Always use safety gloves.

Checking and Replacing the V-Belt and Clutch

1.After 200 hours of operation, remove the upper belt cover to check the V-belt tension.Tension is proper if the belt bends about 10 mm when depressed strongly with finger between shafts. Loose or worn V-belts reduces power transmission efficiency, causing weak compaction and reduces the life of the belt itself.

■Replacing the V-belt CAUTION

Whenever the compactor's vibration becomes weak or lost duringnormaloperationregardlessofoperationhours,check theV-belt and clutch immediately.

Replacing the V-belt

Remove the upper and lower belt covers. Engage an offset wrench (13 mm) or the like to vibrator pulley (lower) fastening bolt. Engage waste cloth or the like at midway of V-belt on the left side and while pulling it back strongly, rotate the offset wrench clockwise so that the V-belt will come off.

Reinstalling the V-belt

Engage V-belt to lower vibrator pulley and push the V-belt to left side of upper clutch and, in the same manner as in removal, rotate offset wrench clockwise so that the V-belt goes back on.

Checking Clutch

Check the clutch simultaneously with V-belt checking. With belt removed, check outer drum of the clutch for seizure and "V" groove for wear or damage with your eyes. Clean the "V" groove as necessary. Wear of lining or shoe should be checked frequently. If the shoe is worn, power transmission becomes deficient and slipping will result.

MVC-88VGE/VGEW PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #1 (01/11/11) — PAGE 21

Page 21
Image 21
Multiquip MVC-88VGE/VGEW- MAINTENANCE, Air Cleaner CHANGING VIBRATOR OIL, Checking and Replacing the V-Belt and Clutch