Multiquip MVH-150GH, MVH-150D Do not over fill, Starting section of this manual, Flow of fuel

MVH-150GH/D COMPONENTS (HONDA GX200K1 ENGINE)

Figure 2. Engine Controls & Components

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank.Make sure cap is tighten securely.

	DO NOT over fill.
2.	Throttle Lever – Used to adjust engine speed (fast-slow).
3.	Recoil Starter (pull rope) –Type of engine starting method.
	Alternate type would be electric start (ignition key).
4.	Starter Grip – Grip this handle to start engine. See engine
	starting section of this manual.
5.	Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop
	the flow of fuel.

7.	Air Cleaner – Prevents dirt and other debris from entering
	the fuel system. Remove wing-nut on top of air filter
	cannister to gain access to filter element.
8.	Spark Plug – Provides spark to the ignition system. Set
	spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean
	spark plug once a week.
9.	Muffler – Used to reduce noise and emissions.
10.	FuelTank – Gasoline engine Holds 3.8 quarts of unleaded
	gasoline. Diesel engine holds 3.4 quarts of diesel fuel.

6. Choke Lever – Used in the starting of a cold engine, or in cold weather conditions. The choke enriches the fuel mixture.

PAGE 12 — MVH-150GH/D — OPERATION AND PARTS MANUAL — REV. #2 (12/04/06)