Multiquip MVH-200DA manual Grip to maneuver the compactor, Compactor not to move neutral

MVH-200DA — PLATE COMPACTOR COMPONENTS

Figure 3. MVH-200DA Components

Figure 3 illustrates the location of the major components for the MVH-200DA Reversible Plate Compactor.The function of each component is described below:

1.	Hand Grip – When operating the compactor use this hand
	grip to maneuver the compactor.
2.	Forward & Reverse Lever – Push the lever forward, the
	compactor will move in a forward direction, pull the lever
	backwards, the compactor will move in backwards direction.
	Placing the lever in the middle (midway) will cause the
	compactor not to move (neutral).
3.	Handle Bar – When operating the compactor, this handle
	is to be in the downward position. When the compactor is
	to be stored, move the handle bar to the upright position.

4.Guard Hook - Used to lift the machine with crane or other lifting device.

5.Stopper - Locks the handle in place in the upward position for stowing.

6.	Engine –This plate compactor uses a YANMAR L70EE-
	DVMK engine. Refer to the owner’s manual for engine
	information and related topics.
7.	Belt Cover – Remove this cover to gain access to the V-
	belts. NEVER run the compactor without the V-belt cover. If
	the V-belt cover is not installed, the possibility exists that
	your hand may get caught between the V-belt and clutch,
	thus causing serious injury and bodily harm.
8.	Base Plate – Designed to compact sand, clay, and asphalt.
9.	Oil Tank – Fill with proper grade of engine oil.

10. Vibration Case – Encloses the eccentric, gears and counter weights.

11. Shock Absorber – Protects plate compactor from damage by absorbing vibration during operation.

12. Throttle Lever – Controls the speed of the plate compactor. Place straight vertically to start, push fully counterclockwise for full throttle and fully clockwise to stop plate compactor.

PAGE 14 — MVH-200DA PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (03/21/05)