Multiquip MVH-200DA manual Engine Oil Replacement, Air Filter

Engine Oil Replacement:

1.Replace engine oil, first in 25 hours of operation and every 50 to 100 hours afterwards.

2.Drain the engine oil when the oil is warm as shown in Figure 16.

Figure 16. Engine Oil (Draining)

MVH-200DA — MAINTENANCE

3.Clean foam element in warm, soapy water or nonflammable solvent. Rinse and dry thoroughly. Dip the element in clean engine oil and completely squeeze out the excess oil from the element before installing.

Figure 17. Engine Air Filter

Hydraulic Oil

3.Remove the oil drain bolt and sealing washer and allow the oil to drain into a suitable container.

4.Replace engine oil in the oil tank with recommended type oil as listed in Table 4. Engine oil capacity is 1.16 quarts (1.1 liter). DO NOT overfill.

5.Install drain bolt with sealing washer and tighten securely.

Air Filter:

1.Remove the air cleaner cover and foam filter element as shown in Figure 17.

2.Tapthepaperfilterelement(Figure 17)severaltimesonahard surfacetoremovedirt,orblowcompressedair[notexceeding 30psi(207kPa,2.1kgf/cm2)]throughthefilterelementfromthe air cleaner case side.

CAUTION - Cleaning the Engine Air Filter

NEVER brush off dirt.Brushing will force dirt into the fibers and causepoorperformanceinyourairfilter.Replacethepaperfilter element if it is excessively dirty.

1.Check hydraulic oil in every 100 hours of operation. With handle bar positioned vertically (storage position), remove oil level check plug (Figure 18) from the top of hydraulic pump and check for proper oil level.

2.Replace hydraulic oil after first 200 hours and in every 1,000 hours of operation.

Figure 18. Oil Level Check Plug

MVH-200DA PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #0 (03/21/05) — PAGE 21