Multiquip QP4TE Basic Engine, Danger, Engine Controls and Components INITIAL SERVICING, Fast

BASIC ENGINE

Figure 3. Engine Controls and Components

INITIAL SERVICING

The engine (Figure 3) must be checked for proper lubrication and filled with fuel prior to operation. Refer to the ROBIN engine service manualforinstructions anddetailsforproperoperationandservicing.

1. Muffler – Used to reduce noise and emissions.

WARNING

Engine components can generate extreme heat.To prevent burns, DO NOT touch these areas while the engine is running or immediately after operating. NEVER operate the engine with the muffler removed.

2. Air Cleaner – Prevents dirt and other debris from entering the fuel system. Remove wing-nut on top of air filter cannister to gain access to filter element.

3. Fuel Tank – Holds unleaded gasoline. For additional information refer to ROBIN engine owner's manual.

4. Fuel Filler Cap – Remove this cap to add unleaded gasoline to the fuel tank. Make sure cap is tightened securely. DO NOT over fill.

DANGER

5.	Throttle Lever – Used to adjust engine RPM speed (lever
	advanced forward SLOW, lever back toward operator
	FAST).
6.	Recoil Starter (pull rope) – Manual-starting method. Pull
	the starter grip until resistance is felt, then pull briskly and
	smoothly.
7.	Choke Lever – Used in the starting of a cold engine, or in
	cold weather conditions. The choke enriches the fuel
	mixture.
8.	FuelValve Lever – OPEN to let fuel flow, CLOSE to stop
	the flow of fuel.
9.	Spark Plug – Provides spark to the ignition system. Set
	spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean
	spark plug once a week.

10. Engine ON/OFF Switch – ON position permits engine starting, OFF position stops engine operations.

11. Oil Drain Plug – Remove this plug to drain engine oil from the crankcase.

12. Oil Dipstick/ Filler Cap– Remove the filler cap dipstick when checking the engine oil level. Add engine oil through this filler port. See Table 5 for recommended type engine oil.

Adding fuel to the tank should be done only when the engine is stopped and has had an opportunity to cool down. In the event of a fuel spill, DO NOT attempt to start the engine until the fuel residue has been completely wiped up, and the area surrounding the engine is dry.

NOTE

Operating the engine without an air filter, with a damaged air filter, or a filter in need of replacement will allow dirt to enter the engine, causing rapid engine wear.

PAGE 16 —OPERATION AND PARTS MANUAL — REV. #1 (10/10/08)