Multiquip manual STOW SS-233 SUBMERSIBLE PUMP - COMPONENTS, Submersible Pump Components

STOW SS-233 SUBMERSIBLE PUMP — COMPONENTS

Figure 1. Submersible Pump Components

Figures 1 shows the location of the basic components, for the STOW Model SS-233submersible pump.Listed below is a brief explanation of each component.

1.AC Power Cable – This unit is supplied with a 20 ft. (6.1 meters) AC power cable. Always check the cable for signs of wear. NEVER! use a defective power cable.Replace the cable immediately if the cable is worn or defective.

2.2-Inch NPT Fitting – Install this fitting into the discharge port of the pump

3.Discharge Port – Connect a 2" NPT hose to this port. Remember to adequately support the discharge hose to avoid stress on the pump.

4.Thermal Overload Protection –This pump has an internal thermal overload protection device that will shut-down the motor in the event of high operating temperatures.The motor will automatically restart once the temperature returns to an acceptable operating temperature.

5.Strainer Base – This strainer base is made of durable plastic. DO NOT pump large objects or debris with this pump.This pump is for pumping water only.For de-watering purposes, always place the strainer base on a platform.

6.Electric Motor – This unit utilizes a single-phase, 115 V, 0.5 HP electric motor. Consult with a licenced electrician before connecting motor to a power source. Observe all city and local safety codes.

7.Volute/Impeller – Impellers are constructed of thermo plastic to minimizes wear and prolong service life.

PAGE 10 — STOW SS-233 SUBMERSIBLE PUMP — OPERATION MANUAL — REV. #2 (05/03/04)