STOW SS-233 SUBMERSIBLE PUMP — OPERATION
4.NEVER! grab or touch a live power cord (Figure 4) with wet hands, the possibility exists of electricalshock, electrocu- tion and even death.
WET
HANDS
POWER
CORD
(POWER ON)
Figure 4. Power Cord (Wet Hands
DANGER:
NEVER! grab or touch a live power cord. DO NOT stand in water when connecting the pump's power cord into a voltage source.The possibility exist of electrical shock, electrocution and possibly death!
3.If all of the pump's electrical requirements have been met, insert the power plug (Figure 5) on the pump into the power source receptace. Make sure the extension cord is of proper size,seeTable3. It is recommended thatthepump'spower cord be plugged into a GFCI receptacle to prevent the possibility of electrical shock.
Figure 5. Conneting the Power
4.Wait a few seconds and water should begin to flow from the discharge hose.
5.If water is not flowing from the discharge hose or not flowing freely after a few minutes, remove the power from the pump and check the system for leaks.
Pump Shut-Down/Clean-up
1.Remove the power from the pump by turning off the circuit breaker or switch that provides power to the pump. Remem- bertomakesurethathandsaredry(notwet),andfeetarenot standing in water when removing or disconnecting power from the pump.
2.Usingtheliftingrope,liftthepumpupfromitscurrentposition. Remove the discharge hose from the discharge port on the pump.
3.Ifthepumpwasusedtopumpmud,gritorsilt,flush vigorously with clean water.
4.Removethepumpfromthewater.Wipeoffanymudordebris that might have attached itself to the pump.
5.Store pump in a clean dry place away from dirt and debris.
WARNING:
NEVER! cut or remove the ground prong from the pump's AC power cord.
WARNING:
This pump is supplied with a grounding conductor and a
PAGE 12 — STOW
