Branch B Channel 1

8.Select Save Setup / Save and Reboot to save the configuration to the MultiVOIP.

9.Assuming a Bogen PCMZPM is located at Corporate, connect a RJ11 phone cord to channel 1 FXS/FXO jack on the Corporate MultiVOIP. Connect the two wires on the other end of the phone cord to the Zone A + and – leads on the PCMZPM. Connect another RJ11 phone cord between channel 2 FXS/FXO jack and the Zone B + and – leads on the PCMZPM. A cord with an RJ11 plug on one end and tinned leads on the other end is included for this purpose. Caution: set the PCMZPM output selector switch to Low Power

10.At the Branch sites, connect a RJ11 phone cord between the MultiVOIP channel 1 FXS/FXO jack and the TIP/RING leads of the speaker amplifier (TPU-15, for example). You cannot connect the speaker directly to the MultiVOIP.

11.When all MultiVOIPs are powered on , a permanent audio connection will exist between Corporate MultiVOIP channel 1 and Branch A MultiVOIP channel 1. Another permanent audio connection will exist between Corporate MultiVOIP channel 2 and Branch B MultiVOIP channel 1. You can now make pages From Corporate to Branch A and/or Branch B remote sites.

12

Page 12
Image 12
Multitech MVP130-BG manual