Changing the Hex Bit
The Hex bits are designed for specific screw guns such as the MK6827/HITACHI W8VB screwdrivers. To change or insert the Hex bit, first cycle the tool against a table, use the Hex bit change tool to hold the tool in the fully actuated position, ensure it is secure and cannot spring out (Photo 7). Slide the Hex bit into the tool so that the shank sticks fully out of the bottom. The Bit-retaining clip can then be attached or removed. Place the clip in the groove and the clip against the edge of a table. Push slowly and firmly to engage clip. This clip is important as is prevents the hex bit from accidentally hitting the feed latch, as well as reducing problems if the bit happens to stick to a screw. Please insure that it always installed on the bit before use. Carefully cycle the tool against table again to remove the bit change tool to prevent damage.
Putting Bit clip on
taking Bit clip off
7
The Bit-Retaining clip is important as is prevents the hex bit from accidentally hitting the feed latch, as well as reducing problems if the bit happens to stick to a screw. Please insure that it always installed on the Hex bit before use. The adaptor assembly is only used with the Square and Phillips bits.
Changing the Hex Bit – Cont’d
