MURO VL71-FLR manual Loading Visrope, Setting Visrope, Switching magazine inner lid

￿Loading VISROPE￿

1.Setting VISROPE

Open the magazine cover while pulling the magazine lever.

Set the VISROPE to the magazine as shown below. (Remove the rubber band from the VISROPE.)

2. Switching magazine inner lid

Lift the inner lid while holding the inner lid stopper on the magazine cover. Insert the inner lid until it snaps in the orientation corresponding to the screw length.

3. VISROPE types and stopper block adjustment

Two types are available in the VISROPE for VL71-FLR, 30mm type and 22mm type. Depending on the type, the position of the guide differs and the stopper block needs to be adjusted to fit for the screws used.

*The first VISROPE has an extended plastic strip as shown below, which is needed to drive the first screw. Please confirm the presence of this extension when loading.

*The stopper block fixing cap screw, when loosened too much, can cause its head to protrude. Pay due attention to it.

3