Murphy PVS-5 specifications Mounting, Wiring Diagram, Accessories

Mounting

The PVS-5 can be mounted under or behind the dash using cable ties or screws. Refer to the following installation examples when mounting the power supply device.

CAUTION: The mating connector does not have a water tight seal. If the device is mounted in a location exposed to the risk of moisture, then the device should be mounted in an orientation that will protect the connector from water seepage (connector facing down) or sealed against moisture.

Mounted using two #8 screws

Mounted using cable ties through

each of the mounting holes.

Mounted using one cable tie

across the device.

Wiring Diagram

The pin out information for the 4 pin connector is shown below.

Mating Connector – Tyco Electronics AMP Mini

Universal Mate-N-Lok Plug Housing 4 Position,

AMP P/N 172338-1

Murphy P/N 00-00-6935

Accessories

Model Wiring harness Rendering Wiring Harness Designation Schematic Part Number

PVWM-J	78-00-0479
PVM Gage Harness	78-00-0490
	78-00-0503

Warranty - A limited warranty on materials and workmanship is given with this FW Murphy product. A copy of the warranty may be viewed or printed by going to www.fwmurphy.com/support/warranty.htm