Murray 11053x92a manual Outside of the lower handle as you, Tighten the knobs

ASSEMBLY

3.	Insert the right lower handle into the
	mounting channel (see Figure 3). Make
	sure the flat end at the top of the handle
	is facing inward.
4.	Mount a spacer on each screw. Push
	the screws through the tine shield, the
	lower handle, and half way through the
	engine casing (see Figure 4).
5.	Insert the left lower handle into the
	mounting channel (see Figure 3). Make
	sure the flat end at the top of the handle
	is facing inward.
6.	Push the screws through the engine
	casing, the lower handle, and the tine
	shield. Secure with spacers and lock-
	nuts as shown in Figure 4. Do not tight-
	en at this time.
7.	Remove the fasteners from the upper

Left Lower

Handle

Right Lower

Handle

Mounting Channel Figure 3

	handle (see Figure 5).
8.	Assemble the upper handle to the lower
	handles with the fasteners removed in
	step 7.
9.	Tighten the knobs.
	NOTE: To tighten the knobs, hold the

Spacer

Spacer

Screw

Locknut

	curved carriage bolt head against the
	outside of the lower handle as you
	tighten the knobs.
10.	Tighten the locknuts that hold the ends
	of the lower handles (see Figure 4).
	Tighten only enough to firmly hold the
	handles.
	CAUTION: Over tightening the lock-
	nuts can change the shape of the han-
	dle and damage the engine casing.
11.	Mount the throttle control on the right
	side of the upper handle with the screw
	as shown in Figure 5.
12.	Attach the throttle control cable to the
	lower handle with the cable fastener.
	Make sure the throttle control cable is
	routed to the outside of the handles.

Tine Shield

Figure 4

Screw Upper Handle

Flat

Washer

Curved Knob

Washer

Throttle Control

Carriage Bolt

Cable Fastener

Figure 5

F-051302L 8