Murray 22" Push Preparation, Unpacking Instructions, Rear Wheels Hi-Wheel Models With Axle Knobs

PREPARATION
UNPACKING INSTRUCTIONS		Upper Handle
The mower was fully assembled at the factory.
When the mower was put in the carton, the
handle was put in the storage position. To put
the handle in the operating position, follow the	Knob
steps below.		Lower Handle
Handle
1. Remove the mower from the carton.		Knob
2. Put the lower handle in the operating posi-
tion. Make sure the lower handle is be-
tween the locking tabs (Figure 1).
		Figure 1

3.Put the upper handle in the operating position. Tighten the knobs.

CAUTION: Be careful when you fold or raise the handle. Do not damage the cables. A cable that is bent will not work correctly. Before you use the unit, re- place a bent or damaged cable.

4.To attach the recoil-start grip to the rope guide, twist the rope through the rope guide mounted on the right side of the han- dle (Figure 2).

NOTE: If you cannot attach the recoil-start grip because the rope is too short, hold the engine stop lever against the handle. Slowly pull the recoil-start grip.

Rear Wheels (Hi-Wheel Models With Axle Knobs)

1.Remove the washers and axle knobs from the axle bolts (Figure 3).

2.Mount the rear wheels onto the axle bolts and fasten with the washers and axle knobs.

Recoil-Start

Grip

Rope

Guide

Figure 2

Rear Wheel	Axle Knob
	Washer
Axle
Bolt
	Figure 3

F-030426L 11