Murray 387002x92D manual Maintenance, How To Replace The Motion Drive Belt, Removal, Installation

Models: 387002x92D

1 52
Download 52 pages 2.9 Kb
Page 29
Image 29
HOW TO REPLACE THE MOTION DRIVE BELT

MAINTENANCE

HOW TO REPLACE THE MOTION DRIVE BELT

REMOVAL

1.Remove the mower housing. See the instructions on “How To Remove The Mower Housing”.

2.Completely push the pedal forward and engage the parking brake.

3.Remove the idler pulley (Figure 25).

4.Loosen the belt guides that are around the drive pulley.

5.Remove the motion drive belt from the drive pulley.

6.To remove the motion drive belt from the stack pulley, pull the front end of the belt under the stack pulley and then back between the stack pulley and the belt guide plate (Figure 26).

7.Put the end of the motion drive belt from the drive pulley through the hole for the shift lever (Figure 27). Move the shift lever and push the belt under the shift lever.

8.Remove the motion drive belt. A correct replacement part or assistance is available from an Authorized Service Center in your area.

INSTALLATION

1.Slide the motion drive belt between the stack pulley and the belt guide plate (Figure 26). Install the motion drive belt on the top pulley of the stack pulley. Make sure the “V” side of the belt is against the pulley.

2.Push the motion drive belt through the hole in the frame for the shift lever (Figure 27). Lift the end of the belt over the shift lever and back down through the hole in the frame.

3.Install the end of the motion drive belt around the drive pulley (Figure 25).

4.Tighten the belt guides that are around the drive pulley.

5.Put the belt around the idler pulley. Assemble the idler pulley. Fasten the idler pulley with the hex nut. Make sure the flat side of the belt is against the idler pulley as shown. Also, make sure the belt is not twisted.

6.Make sure the motion drive belt is inside all the belt guides (Figure 25 and Figure 26).

7.Before you use the unit, check the adjustment of the clutch. See the instructions “How To Check And Adjust The Clutch”.

8.Install the mower housing. See the instructions “How To Install The Mower Housing”.

Drive Pulley

Motion

Drive Belt

Idler Pulley

Loosen The

Belt Guides

Figure 25

FRONT

Belt Guides

Belt Guide

Plate

Motion

Drive BeltREMOVAL

Stack Pulley

Figure 26

Shift Lever

Motion Drive Belt INSTALLATION

Figure 27

F-050717L

29

Page 29
Image 29
Murray 387002x92D manual Maintenance, How To Replace The Motion Drive Belt, Removal, Installation