ASSEMBLY

HOW TO INSTALL THE SEAT

Use the fasteners shown below to install the seat. The fasteners are shown at full size.

(A)

(B)

1001054

17x47

1.Carefully remove the plastic bag from the seat.

2.Align the holes in the seat hinge to the holes in the seat (Figure 1). Fasten the seat to the seat hinge with the fasteners as shown.

3.Check the operating position of the seat. If the seat needs to be adjusted, loosen the two wing bolts. Slide the seat forward or backward along the seat adjusting holes as shown. Tighten the wing bolts (A).

Seat

 

Seat Hinge

 

Seat

Adjusting Hole

B

A

 

 

Figure 1

HOW TO ASSEMBLE THE STEERING WHEEL

Fasteners are not required to assemble the steering wheel. Attach the steering wheel as follows:

1.Make sure the front wheels point forward.

2.Look at the hub of the steering wheel. Make sure the locking clip is in place inside the hub.

3.Slide the cover over the steering post (Figure 2).

4.Slide the steering wheel onto the steering post. Push on the steering wheel. The steering wheel will lock onto the steering post. Pull on the steering wheel. Make sure the steering wheel is locked in place.

5.Some models have an decal in the parts bag. Attach the decal to the center of the steering wheel as shown.

Decal

(Optional)

Steering Wheel

Hub

 

 

Cover

Steering Post

 

 

Figure 2

HOW TO ASSEMBLE THE GAUGE WHEELS

Use the fasteners shown below to install the gauge wheels. The fasteners are shown at full size.

(A)

(B)

31x11

17x91

 

1.Attach the gauge wheels to the axle bolts with the fasteners.

NOTE: The axle bolt is mounted in the LOW position. To change the position to a higher cutting position, see “How To Adjust The Gauge Wheels” in the Maintenance section.

Axle Bolt

B

A

Gauge Wheel

Figure 3

F–040729L

11

Page 11
Image 11
Murray 425620x92A manual HOW to Install the Seat, HOW to Assemble the Steering Wheel, HOW to Assemble the Gauge Wheels