ASSEMBLY
HOW TO RAISE THE HANDLE
1.Loosen the knobs and raise the upper handle to the upright position. See Figure 2.
2.Tighten the knobs. Make sure the knobs are to the outside of the handles as shown in Figure 2.
3.Insert the end of the control rod, from RIGHT to LEFT, through the hole in the front wheel arm. Attach with hair pin found in parts bag. See Figure 3.
4.Push down on the handle to tilt the unit back.
Knobs
Upper
Handle
Control
Rod
Figure 2
Front
Wheel Arm
Hair Pin
5.Insert the other end of the control rod, from RIGHT to LEFT, through the hole in the depth control lever and fasten with hair pin. See Figure 4.
6.Move the depth control lever forward to the STARTING and TRANSPORT posi- tion.
7.Remove any packing material from the bottom of the unit.
8.To attach the recoil starter rope to the rope guide, twist the recoil starter rope through the rope guide. See Figure 5.
Hairpin
Depth Control
Lever
Control Rod
Figure 4
Rope Guide
Control
Rod
Figure 3
Recoil Starter |
|
Rope | Figure 5 |
|
7 |
