SERVICE AND ADJUSTMENT
HOW TO REPLACE THE BLADE
The blade is subject to wear and damage, such as nicks and dents. This will not gener- ally affect its function.
1.Disconnect the spark plug wire from the spark plug.
The blade is designed to not require sharp- ening. Do not attempt to sharpen the blade. The blade is also reversible. If nicks or dents are excessive, remove the blade and turn it around. This will provide a fresh cut- ting edge. Replace the blade if both sides are worn or damaged.
WARNING: Do not sharpen the blade. Sharpening can damage the blade and cause it to break,
which can cause injury to yourself or to others.
To replace the blade, follow the steps below.
2.Remove the blade locknut that holds the blade to the drive shaft.
WARNING: To remove or tigh- ten the blade locknut, always use the method shown in
Figure 13. Always position the holding wrench on the nut behind the blade.
3.Remove the blade.
4.Install a new blade and blade locknut. Tighten the blade locknut to a torque of
Turn Wrench
To Tighten Locknut
Blade Locknut
Hold Nut,
Do Not Turn
Figure 13
16 |