Murray 22506x9A Preparation, Unpacking Instructions, Rear Wheels Hi-WheelModels With Axle Knobs

PREPARATION

UNPACKING INSTRUCTIONS

The mower was fully assembled at the factory. When the mower was put in the carton, the handle was put in the storage position. To put the handle in the operating position, follow the steps below.

Handle

1.Remove the mower from the carton.

2.Put the lower handle in the opereting posi- tion. Make sure the lower handle is be- tween the locking tabs (Figure 1).

3.Put the upper handle in the operating position. Tighten the wingnuts.

CAUTION: Be careful when you fold or

raise the handle. Do not damage the cables. A cable that is bent will not work

correctly. Before you use the unit, re- place a bent or damaged cable.

4.To attach the recoil-start griptothe rope guide, twist the rope through the rope guide mounted on the rightside of the han- dle (Figure 2).

NOTE: If you cannot attach the recoil-start grip because the rope is too short, hold the engine stop lever against the handle. Slowly pull the recoil-start grip.

_gnut

Lower Handle

Offset Hole

Locking

Tabs

Handle

_/Wingnut

Figure 1

Axle Knob

Rear Wheel

Washer _X

Rear Wheels (Hi-Wheel Models With Axle Knobs)

1.Remove the washers and axle knobs from the axle bolts (Figure 3).

2.Mount the rear wheels onto the axle bolts and fasten with the washers and axle knobs.

Axle Bolt

Figure 3

F-9852611