1.Connect one end of the small cable supplied to the female receptacle on the back of the cruise control labeled OUTPUT ~16V 3W.
2.Connect the other end of the small cable supplied to the motor power supply housing (on the bottom back or side of the turntable). Connect the small male end of the cable attached to the wall wart power supply to the female input on back of the cruise control labeled INPUT ~16V 1A.
3.Move the belt to the larger 45rpm motor pulley position.
4.Plug the AC end of the wall wart power supply into the wall.
Turntables without and external wall wart power supply (120V motor) should be connected to the - OUTPUT ~120V 3W receptacle on the cruise control. There is no need to use the small connecting cable supplied with the cruise control. Store this cable in a safe memorable space in case you upgrade your turntable to a more contemporary 16V motor model.
c r u i se co n t r o l 2 . 0
3 3 / 4 5
s l o w e r s t an db y fa s t e r
OPERATION
Press the 33/45 button on the front of the cruise control to change speeds from 33.3/45rpm.
Press and hold the 33/45 button to engage standby which stops the motor from spinning. Push the button again to begin the motor spinning. The selected speed will be displayed digitally in the front display window on the cruise control.
Please always start the turntable at 33.3 rpm and then switch to the higher desired speed.
4
