A5CR.SPECIFICATIONS. POWER AMPLIFIER
Output : | Power : | 255 | Watts per channel into 8 Ohms (24dBW), | |
|
| 416 | Watts per channel into 4 Ohms | |
| Voltage, RMS : | 45.2 Volts 20Hz to 20kHz | ||
| Voltage, | 118.8 Volts |
| |
| Current | 200 | Amps |
|
| Damping factor : | 170 |
|
|
| Output devices per channel : | 8 |
|
|
Line inputs : |
|
|
| |
| Total harmonic distortion + noise, | < 0.01% 20Hz to 20kHz | ||
| Signal / noise ratio | > 109dB | ||
| Input sensitivity for 255 Watts into 8 Ohms | 1.5V |
| |
| Input impedance | 100k Ohms | ||
| Channel separation | > 90dB typical | ||
| Frequency response | 10Hz to 100kHz, +0, | ||
Inputs : | “A” | 1 pair line level RCA connectors | ||
| “B” | 1 pair line level RCA connectors | ||
Outputs : |
| 2 amplifier channels via 2 pairs per channel binding posts | ||
|
| 1 pair RCA loop output sockets | ||
Power requirement : | 100 | / 115 / 230Volts AC 50 / 60Hz (factory | ||
|
| 750 | Watts maximum into 8 Ohms, 70 Watts idle | |
Weight : |
| 19.1 kg, | 42.1 lbs unit only, unboxed | |
|
| 23.75 kg, | 52.4 lbs in shipping carton | |
Dimensions : | 440 mm, | 17.3 inches wide | ||
|
| 125 mm, | 4.9 inches high including feet | |
|
| 400 mm, | 15.75 inches deep including terminals | |
Standard accessories : | IEC type mains lead |
Musical Fidelity reserves the right to make improvements which may result in specification or feature changes without notice.
Issue 1 : November 2004 | A5 CR Power Amplifier | Instructions for use | Page 7 of 7 |