Caratteristiche Tecniche

Output: Power Voltage Voltage

Current peak-to-peak Damping factor Output devices

Balanced Line input: THD+N Signal / noise ratio Input impedance Frequency response

Connections:

Line level inputs

Line level outputs

Speaker outputs

Power requirement:

Mains voltages:

Standard accessories:

35 Watts per channel into 8 Ohms (1 5.5dBW),

17 Volts RMS 20Hz to 20 kHz

47 Volts Peak-to-peak

20Amps 130

2 pairs per channel

<0.014% unwtd, 20Hz to 20 kHz

>96dB ‘A’-weighted

40k Ohms

10Hz to 50 kHz, +0, -1dB

1 pairs line level XLR (balanced) connectors

4 pairs line level RCA connectors

1 pair line level RCA connectors, constant level TAPE outputs

1 pair line level RCA connectors, preamp outputs for e.g. biamping 2 pairs 4mm banana plug/binding posts

11 5/230VAC 50/60Hz (factory pre-set) 100VAC 50/60Hz (alternative)

330 Watts continuous

unit only, unboxed in shipping carton

wide

high including feet

deep (front to back) including terminals

IEC type mains lead (10-Amp type),

AMS35i remote control

Varta CR2450 Li-Mn battery

Musical Fidelity reserves the right to make improvements which may result in specification or feature changes without notice.

Issue 2

Page 10 of 11

Musical Fidelity AMS35I manual Caratteristiche Tecniche