INPUT CONNECTIONS
Using good quality
IEC mains power inlet
LOUDSPEAKER CONNECTIONS
CONNECTIONS
All input, output and power connections should be made with the mains power switched OFF.
OUTPUTOUTPUT
These RCA sockets have “line level” audio “loop” output routed from either A or B input by the selector switch on the front panel.
They are for onward connection to another amplifier if required.
(See page 6 under
The
However, do not attempt both speaker connection methods at the same time.
Conventional stereo use :
Connect each of your loudspeakers to the pair of terminals on the back panel marked LEFT and RIGHT SPEAKER OUTPUT. The wiring must be “in phase”, namely, the red (+) and black
Bridge mode :
Connect a single (mono) loudspeaker between LEFT and RIGHT red (+) terminals only
Note that in this mode, the
Important :
*The load impedance must not be less than 4 ohms.
*Do not make any earth connection to the speaker terminals.
Page 4 of 7 |
| Page 5 of 7 |