N-Tron 400 manual Led, Color Description, Applying Power Side View

LED’s: The table below describes the operating modes:

LED	Color	Description
	GREEN	Power is Applied
	OFF	Power is OFF
!	RED	Controller HW Error
	OFF	No Errors. Normal
		Operation.
LNK	GREEN	Link between ports
		established
	OFF	No Link between ports
ACT	GREEN	Data is active between
		ports
	OFF	Data is inactive between
		ports

APPLYING POWER (Side View)

Unscrew & Remove the DC Voltage Input Plug(s) from the side header Install the DC Power Cables into the Plug(s) (observing polarity).

Plug the Voltage Input Plug(s) back into the side header.

Tightening torque for the terminal block power plug is 0.22 Nm/0.162 Pound Foot. All LED’s will flash ON Momentarily (including the Error LED)

Verify the Power LED stays ON (GREEN). Verify the Error LED is OFF (after a few seconds).

Note: Only 1 plug is required to be connected to power input for minimal operation. For redundant power operation, V1 and V2 plugs must be connected to separate DC Voltage sources. Use wire sizes 16-28 gauge.

Recommended 24V DC Power Supplies, similar to 100VAC/240VAC:

N-Tron’s NTPS-24-1.3, DC 24V/1.3A

Rev 102507 10